I was wondering is it possible to have two different interfaces in the software like for example one network card has the WAN(Public) IP address and the other has the Lan IP Address(192.168.1.2) as I just realized when trying to setup the Protector on my network, that when changing the IP Address of the protector to the WAN(Public) IP Address because it states it is offline, that then prohibits me from accessing it then and then I have to start all over from scratch because I cannot access the protector web interface anymore.
Is this doable? Or am I not seeing where the parts are at, that indicate in VMware ESXI how to setup the WAN & Lan IP Addresses and Network Interfaces to work.
As I checked for the VMware ESXI server Install Guide PDF, it says 404 on your website so there is that as well.
Reply:
This can be done with the DMZ (eth2) network card. That card can be configured with a local IP address and a different subnet. Then, to access the web interface, it can be done from a computer in the DMZ subnet. Pay attention: there is no dhcp, so all the devices in the DMZ subnet must have a static IP, otherwise it's necessary to install a dhcp server in the subnet.
The same will be possible using network cards from eth3 upwards as soon as firmware 52 is released.
Comments
0 comments
Please sign in to leave a comment.