Autonomous Sonar Robot Question

I’ve tried to scan our internal network with the Autonomous Sonar Robot.

The virtual machine has all the rights on the firewall to scan the network/targets.

But when i click  “Set starting Point & Enable Robot” . The scan very quickly stops after a few seconds and there

are no results in Scanned Targets.

Reply

First of all the function must be enabled. Click on the enable slider and
press OK. Then, in theory nothing must be done and the robot will start
alone. The snapshot (Starting Point) is only necessary to create a list of
targets that shuld be excluded from the next scans. If all the targets in
the selected template should be scanned for vulnerabilities, no snapshot
must be done, and the robot will do the job.